Fourth of July: Fourth of July Chair Covers (4th of July Crafts)

Fourth of July Chair Covers

Easy-to-make chair covers for Fourth of July and every holiday or celebration at home or school; another great craft from

What you’ll need

  • Felt
  • Fabric glue or needle and thread
  • Pins
  • Repositionable glue (we used nontoxic Aleene’s Spritz-On Reposition-It Tacky Glue, available at craft stores)

helpful tip

Check out these other chair covers for all the different seasons!
Birthday Throne Chair Covers
Valentine Chair Covers
Bunny Chair Covers
Ghost Chair Covers
Turkey Chair Covers
Snowman Chair Covers

How to make it

  • Fourth of July Chair Covers - Step 1

    The Slipcover:
    This easy slipcover, made from a few yards of felt, serves as a backdrop for a year’s worth of decorations.
    First, decide how far down the back of your chair you want the slipcover to hang. Measure from that point up and over the top of the chair, then down to the seat (or stop at the arms if your chair has them). This is the total length of felt you’ll need for each cover. Now measure the width of the chair back at its widest point; add to that measurement the thickness of the chair back and 1 inch for the seams (1/2 inch per side).

  • For each chair, cut a piece of white felt to fit your measurements. Ours ran 1 1/2 yards long and 2/3 yard wide.

  • Fold the felt over the chair and pin the sides in place. Remove the cover and sew up the sides or glue them together with fabric glue. If you sew them, turn the cover inside out.

  • Fourth of July Chair Covers - Step 4

    The Decorations
    Here’s a simple way to honor our country’s independence. You’ll need to measure the blue banner and 3 red stripes to fit your chairs. The stars are made by tracing a star-shaped template (you can draw your own or download our flag template) onto the banner, then cutting them out to reveal the white slipcover underneath.
    (To view the .pdf files, you’ll need Adobe Reader which is available for free from the Adobe site.)

  • Trace the templates on to felt (or other lightweight materials such as ribbon) and then cut them out. Dimensions will depend on the size of your chair covers.

  • Spray the back of each piece with a thin layer of repositionable glue, then press them onto the slipcovers or layer them on top of one another. (If little hands peel off any of them, just apply another layer of glue and press them back on.) Tip: If you get a clump of glue, spread it out with a paintbrush so it doesn’t leave a mark on the white felt.

  • Store the pieces in plastic bags, preferably with the sticky sides facing away from one another. Next time you use them, spritz on another layer of glue.

  • Leave a Reply